Fault 1: the reducer does not turn
Phenomenon: The belt motor and liquid coupling are running, the reducer does not rotate, the liquid coupling is easy to melt, the oil level is normal, the backstop has no temperature and no odor.
Solution: From easy to difficult to check, first check the reducer, then check and replace the backstop, and then check the liquid coupling.
Fault 2: The belt conveyor cannot start
Phenomenon: The motor does not rotate.
Solution: Check and eliminate protection faults (stall alarm, dredging chute, reset of pull rope switch, reset of emergency stop button), check motor.
Failure 3: The tape is off
Phenomenon: When the tape conveyor is running normally, the tape starts to deviate along a certain point.
Solution: Check the drum and roller for sticky slime or sundries, check if the tape has accumulated too much coal, and clean up.
Phenomenon: The entire conveyor tape runs to one side.
Treatment method: The drums are not parallel, mostly due to the skew of the tail drum or slime sticking to the tail drum. Phenomenon: The tape is deviating to one side, and the deviation is at the joint of the tape. Handling method: The joint is incorrect, and it should be remade according to standards. Phenomenon: The deviation direction of the tape is inconsistent, and the treatment method is insufficient: adjust the tension of the tape.
The above is the introduction of the editor of Xi'an conveyor production, please contact us if you need!