⎝⎛亚洲城游戏中心⎞⎠

Welcome to the official website of Xi'an Tianyun Automatic Conveying Equipment Co., Ltd.!
Northwest automated transportation professional service provider

Conveyor, conveyor belt manufacturers

Service Hotline

029-88815181

Maintenance and maintenance of Xi'an conveyor!

Author: admin Published Date: 2018/6/16 concern Views: QR code sharing

Is the maintenance and repair of Xi'an conveyor belt clear to everyone? Today I will share with you today.

1. Load point: a: The load point is the vulnerable part of the conveyor belt. The belt speed and the material block size of the conveyor belt operation will impact you and the direction of the load operation. b: Re-loading the material at an angle point in the moving direction of the conveyor belt will only aggravate the wear of the tape surface. The impact of the material team's tape and the off-center feeding will make the tape crawl along the rotating roller to the other side and run away. Causes damage to the edges of the tape. c: The sharp-edged materials with large specific gravity move slowly on the fast-moving tape, which will also scratch and wear the belt surface. d: The closer the guide groove is to the tape, the surface of the tape will be damaged. The gap between the guide groove and the tape is not less than 25mm.

2. Cleaning must implement special protection to keep the surface of all rollers and rollers clean. If there is oil pollution and material accumulation on the equipment, it will have a destructive effect on the operation and the tape itself.

3. All the rollers should run flexibly. Improper selection of the roller diameter will adversely affect the service life of the tape. If there are many attachments on the roller, it will cause the conveyor belt to run away, the rubber cover to wear abnormally, and the belt core to be partially Fatigue rupture. The driving roller is covered with a rubber sheath to improve the friction coefficient, reduce the side force, reduce the slippage of the belt under wet conditions, and prevent the accumulation of material. Slotting of the rubber sleeve improves the cleaning of the sleeve and the belt, and prolongs the life of the roller.

4. The upper and lower supporting rollers shall strictly abide by the regulations for the management and coating of the supporting rollers. This can protect the conveyor belt and reduce the tension of the conveyor belt. When inspecting the idler, remove the foreign matter attached to the surface of the idler. Pay special attention to the lower idler. The attachment may sometimes cause the conveyor belt to deflect, causing damage to the belt edges. Non-rotating idlers may cause the belt to deflect. The damaged and non-rotating rollers must therefore be replaced. The amount of oil should not be too much. Excessive amount of butter and lubricating oil leaking onto the conveyor belt will make the non-oil-resistant belt soften, expand and delaminate. The different positions of the upper rollers and the improper setting of the inclined and curved parts will cause abnormal flexion fatigue of the belt, which will cause the back of the belt to wear and crack, causing wrinkles. When the roller is raised, the belt often floats during operation and spills the material that is transported back, causing damage to the belt.

The above content is the knowledge that Xiaobian shared with you today. If you have any other questions, please feel free to call us! Xi'an Tianyun Automatic Conveying Equipment Co., Ltd. is happy to serve you!


Classic Case

CASE SHOW

Express Lane

support hotline

029-88815181 029-88815181

Email: xatyzdh@xatyzdh.com

QQ: 94050018

x
Customer Hotline

029-88815181

Scan QR code 二维码
客服中心

Customer Service

七乐彩 欢乐拼三张 欢乐拼三张 必赢真人娱乐